7:00 AM, when the install day starts
AC Installation and Replacement in Spring, TX
A full changeout, sized to the house you actually have rather than to whatever tonnage was installed last time. Financing is available for the job when it needs it.
Sizing the system to the house, not to what was already there
Replacing a Spring air conditioner properly starts with the house, not the equipment coming out of it. Square footage, insulation, window orientation and duct layout all change how many tons a home actually needs, and copying whatever tonnage the old unit happened to be skips that math entirely. A full changeout means a new outdoor condenser matched to a new indoor coil, a plenum built to fit the airflow the new equipment actually moves, and duct runs checked and resealed rather than left exactly as they were. Seams get sealed with mastic, a paste that stays flexible instead of drying out and peeling the way tape does after a few Texas summers in a hot attic. The condensate line gets run with a proper slope and a working float switch, so a blocked drain shuts the system down safely instead of finding the ceiling first. Older R-22 systems, the refrigerant most equipment built before the early 2010s used, are being changed out for current R-454B equipment as parts and refrigerant for the old systems get harder and more expensive to find.
What a full install looks like
It starts with a free estimate and a load calculation on the house itself, not a guess based on square footage alone. From there it's the outdoor unit, the coil, a plenum sized to match, and the duct work that feeds it, all replaced or resealed together as one system rather than one part swapped for another. Financing is available, with monthly payments and 0% APR on qualifying systems through Synchrony, so a full changeout doesn't have to happen on the same afternoon the old system quit. Every job is quoted flat rate before anything is disconnected.
KAC Express, licensed in Texas as TACLB33125E. Call (832) 326-5687.
Why R-22 changeouts are common right now
R-22 was the standard refrigerant in residential air conditioning for decades, but production for U.S. use stopped in 2020, and the equipment built to run on it is now well past the age most manufacturers rate for reliable service. When an older R-22 system fails, the honest math often favors a full changeout over a repair: replacement parts have to be reclaimed rather than manufactured, and a new system running on current refrigerant is built to tighter efficiency standards than anything from that era.
A changeout done right gets inspected as a whole system afterward, not just switched on and left. That's the difference between a unit that runs quietly for the next decade and one that's back on the schedule inside a year. It's also why sizing, sealing and the condensate line get the same attention as the equipment itself.